Toshiba GD-1170 - Manual (Page 28)

26
2.SENDING A FAX
3.About Originals (Cont.)
2
Setting originals
When setting originals on the glass
Originals are sent in the order they are placed on the original glass in both memory TX and direct TX
modes.
3 Lower the Reversing Automatic Document Feeder slowly.
1 Raise the Reversing Automatic Docu-
ment Feeder, and place the original A
with its face down on the glass.
• Raise it 60 degrees or more to detect the original.
2 Align the original against the left inner
corner of the glass.
• Different size originals can also be sent in one transmission.
• When LD, LG, LT-R, ST, COMP, A3, A4-R, A5, B4, B5 or FOLIO
originals are placed as shown in the figure on the right, the pre-
entered sender information is printed in the shaded position
shown B in the figure and sent to the remote Fax.
• Entering the sender information ( P.150 “2.Registering the Ter-
minal ID”)
• When transmitting non-standard-sized originals, best results are
obtained by placing the originals horizontally on the glass.
• When LT, ST-R, A4, A5-R or B5-R originals are placed as shown
in the figure on the right, the pre-entered sender information is
printed in the shaded position shown C in the figure and sent to
the remote Fax.
A
B
C