Technika CR-113IPH User Manual
Page 9
7
GETTING STARTED
POWER CONTROL
FM AERIAL
Before using your clock radio for FM reception, unwrap and
fully extend the aerial wire. You may need to adjust the
position of the aerial wire for maximum signal strength.
CONNECTING AC MAINS POWER
Before connecting the power, check that the mains voltage
on the rating plate of the AC adaptor is the same as the
voltage in your area.
Plug the DC cord from the AC adaptor into the DC jack on
•
the back of the unit.
Plug the AC adaptor into the wall socket and switch the
•
mains power on.
The unit is now ready for use.
NOTE:- The AC adaptor may become warm during operation
- this is normal.
SETTING THE TIME AND DATE
When first switched on, the clock and date displays on your
radio will not be set.
Choosing 12 or 24 hour clock time display:
At any time you can press the
•
12/24 hr. button on the
back panel to switch the clock display between 12 or 24
hour time display.
The clock and alarm displays will toggle between 12 hour (with
AM and PM indicator) and 24 hour modes.
NOTE: changing between 12 and 24 hour display will not
affect the clock or alarm settings.
To set the clock time:
Press the
•
TIME button briefly.
The hours digit will flash.
Press the
•
}
/SET+ or
{
/SET- button to set the correct
hour.
Press the
•
/,
/ENTER button to confirm this setting.
The minutes digits will flash.
Press the
•
}
/SET+ or
{
/SET- button to set the correct
minutes.
Press the
•
/,
/ENTER button to confirm this setting.
The clock is now set.
To set the date:
Press and
•
hold the TIME button.
The year digits will flash.
Press the
•
}
/SET+ or
{
/SET- button to set the correct
year.
Press the
•
/,
/ENTER button to confirm this setting.
The month (left) digits will flash.
TIME AND DATE DISPLAYS
STANDBY CONTROL
To turn the radio on:
Press the
•
/ALARM RESET button on the top panel.
The unit will switch on and the iPod, FM or AUX function
indicator will light to show the selected audio source.
To set the radio to Standby:
Press the
•
/ALARM RESET button on the top panel.
The unit will set to Standby. All function indicators will switch
off.
Press the
•
}
/SET+ or
{
/SET- button to set the correct
month.
Press the
•
/,
/ENTER button to confirm this setting. The
date (right) digits will flash.
Press the
•
}
/SET+ or
{
/SET- button to set the correct
date.
Press the
•
/,
/ENTER button to confirm this setting.
The date is now set.
SETTING THE TIME AND DATE USING THE TECHNIKA
iPhone APPLICATION
The time, date and alarm settings for your clock radio can also
be set via a Technika application for iPhone or iPod touch.
Once this application has been installed, you can set time,
date and alarm settings into the application. When you
next dock your iPhone to the clock radio, these settings will
synchronise.
For more details of installing and using the Technika
application, refer to the ‘Advanced Operation’ section on
page 13.