Tricity Bendix TB 100 FF - Manual (Page 11)

11
Freezer
The freezer compartment will become progressively
covered with frost. This should be removed with the
special plastic scraper provided, whenever the
thickness of the frost reaches 1 /
4
”.
During this operation it is not necessary to switch of
the power supply or to remove the foodstuffs.
However, when the ice becomes very thick on the
inner liner, complete defrosting should be carried out
and it is advisable to perform this operation when the
appliance is empty.
For complete defrosting (once or twice a year)
proceed as follows:
Turn the thermostat dial to the „OFF” position (O)
or disconnect the appliance from the mains.
Remove any food from inside the freezer and
fridge; wrap it in several sheets of newspaper and
store in a cool, dry place.
Leave the door open, place a basin on the top shelf
of the refrigerator compartment, under the drain
hole, lift the plug as shown in the figure..
Clean and dry thoroughly.
Replace the scraper in one of the drawers.
Reconnect the appliance to the mains or reset the
thermostat to a functioning position.
After letting the appliance run for a least half an
hour, replace the previously removed food into the
compartment.
Important
A temperature rise of the frozen food packs during
defrosting may shorten their safe storage life.
Never use sharp metal tools to scrape off frost from
the evaporator as this could damage the appliance
beyond repair.
F F
To Change the Light Bulb
1. Disconnect the appliance from the electrical
supply or turn the thermostat to '0'.
2. Take the lamp cover off in the direction of the arrow
and change the bulb. (Type of bulb: 230 V, 15 W,
E 14 thread)
3. Replace the lamp cover and fixing screw.
Spare bulbs are available from your local Tricity Bendix
Service Force Centre.