Topcom BABYTALKER 2500 - Manual (Page 5)

5
ENGLISH
Topcom Babytalker 2500
4.2 Baby unit power supply
1. Connect the small plug of the AC adaptor to the power connector of the baby unit (29)
and the other end of the adapter cable to the electric socket (230V/50Hz).
Only use the enclosed adapter (6V DC / 300mA).
2. Press (17). The power LED will illuminate.
3. Press and hold (17) to switch off the baby unit.
4.3 Parent unit battery Installation
1. Turn the belt clip facing upwards.
2. Turn the screw 90° of the battery cover (14) on the backside of
the baby unit in a counter clockwise direction using a screw
driver. Remove the battery cover (15). Do not try to rotate the
screw further than the position ‘open’.
3. Install the enclosed 2 ‘AAA’ rechargeable batteries following the
polarity as shown.
Do not install alkaline batteries!
4. Close the battery compartment.
5. Press
(2). The LCD display (12) will illuminate.
6. Press and hold (2) to switch off the patent unit.
4.4 Parent unit power supply
1. Connect the power adapter cable to the main
power socket (230V/50Hz).
Only use the enclosed adapter
(6V DC / 200mA).
2. Slide the parent Unit into the charger (6). The red
charging light (7) illuminates.
3. It takes about 13 hours to charge the unit.
4. Press
(2). The LCD display (12) will
illuminate.
5. Press and hold (2) to switch off the patent
unit.
+ -
+ -
PTT