Tricity Bendix FD 852 - Manual (Page 19)

19
Door reversal directions
1. Disconnect from the electricity supply.
2. Remove all loose items, including food, store food
in a cool place.
3. Remove the plastic cover (A) (which has a clip-in-
fitting) masking the bottom hinge;
4. Remove bottom hinge (C).
5. Slide out the lower door from middle hinge (H)
and remove the latter.
6. Slide out the upper door from pin (D), unscrew
the latter and then screw it down into the hinge
provided on the opposite side;
7. Refit the upper door and the middle hinge on the
opposite side.
8. Refit the lower door and bottom hinge (C) on the
opposite side,after having removed the plugs (B)
and screws; these must then be refitted in the
holes on the opposite side;
9. Refit the plastic cover (A)on the bottom hinge;
10.Remove the handles and refit them on the
opposite side. The holes that are not used are to
be masked with the plastic plugs removed.
Warnigs:
After having reversed the opening direction of
the doors, check that all the screws are proporly
tightened.
Attention
After completion of the door reversing operation,
check that the door gasket adheres to the cabinet. If
the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that
case, wait for the natural fitting of the gasket or
accelerate this process by heating up the part
involved with a normal hairdrier.
D
D590
H
PR184
A
B
D589
C
Printed on recyclated paper