TOA Electronics TOA M-9000 - Manual (Page 3)

ZM-9001
Remote Panel
SS-9001
Speaker Selector
Unit: mm
ø130
70 83.5 104
70
38
42
70
31
37
Front view
without panel
83.5
90 – 98
46 – 50
Figure when
mounted
Dimensions of mounting
opening
1-gang electrical box
(not supplied)
If the opening is too small or
too large, the AN-9001
cannot be mounted in the
ceiling or wall. Be sure to
make an opening with
dimensions given above
when mounting.
Unit: mm
72
127 97
66.4
70 66
83.5
90 – 98
46 – 50
83.5 97 104
33
45
32.6
Front view
without panel
Figure when mounted Dimensions of mounting opening
37
6
1-gang electrical box
(not supplied) 38
42
If the opening is too small or too large, the
ZM-9001 cannot be mounted in the wall.
Be sure to make an opening with
dimensions given above when mounting.
Unit: mm
72
127 97
66.4
70 66
83.5
90 – 98
46 – 50
83.5
97 104
33
56
32.6
Front View
without panel
Figure when mounted Dimensions of mounting opening
37
6
1-gang electrical box
(not supplied)
38
42
If the opening is too small or too large,
the ZM-9002 cannot be mounted in the
wall. Be sure to make an opening with
dimensions given above when mounting.
AN-9001 Ambient Noise Sensing
Microphone
ZM-9002
Remote Panel
Unit: mm
30
18 18 70
112
157 177 197
10
1
Type Electret condenser microphone
Phantom Power 14-26 V DC
Current Consumption 7 mA (at 24 V DC)
Directivity Omnidirectional (hemispherical)
Impedance 200 Ω
Rated Sensitivity -5 dB (1 kHz, 0 dB = 1 V/Pa)
Frequency Response 100-10,000 Hz
Output Terminal Removable terminal block (3 pins)
Operating Temperature -10 °C to +40°C
Finish Panel: ABS resin, white
Frame, Case: Surface-treated steel plate
Dimensions ш130 Ч 37 (D) mm
Weight 170 g
Accessory Removable terminal plug (3 pins) × 1,
Box mounting screw (No.6-32UNC x 30) × 2,
Box mounting screw (M4 x 30) × 2
Option 9000 series plug-in module: AN-001T
Note: Since no electrical box is supplied with the unit, prepare it separately.
Applicable Cable Single conductor shielded cable
Line Resistance Under 50 Ω (per line)
Terminal M3 screw terminal, distance between barriers: 7.62 mm
Operating Temperature -10 °C to +40°C
Finish Surface-treated steel plate, white, paint
Dimensions 72 (W) × 127 (H) × 45 (D) mm
Weight 170 g
Accessory Box mounting screw × 2, Panel mounting screw × 2
Note: Since no electrical box is supplied with the unit, prepare it separately.
Applicable Cable Single conductor shielded cable
Line Resistance Under 50 Ω (per line)
Terminal M3 screw terminal, distance between barriers: 7.62 mm
Operating Temperature -10 °C to +40°C
Finish Surface-treated steel plate, white, paint
Dimensions 72 (W) × 127 (H) × 56 (D) mm
Weight 170 g
Accessory Box mounting screw × 2, Panel mounting screw × 2
Note: Since no electrical box is supplied with the unit, prepare it separately.
Power Source Supplied from the optional AD-246 AC adapter or an
external 24 V DC/200 mA power supply.
Current Consumption 120 mA
Control Signal No-voltage make contact nput (polarized),
open voltage: 24 V DC, short-circuit current: 3 mA
Control Power Under 240 W (70 V line)
Speaker Terminal Removable terminal block (2 pins)
Control Terminal Removable terminal block (10 pins)
Operating Temperature -10 °C to +40°C
Finish Case: Surface-treated steel plate
Dimensions 112 (W) × 197 (H) × 30 (D) mm
Weight 530 g
Accessory Removable terminal plug (2 pins) × 6, Removable terminal
plug (10 pins) × 1, Cord clamp × 1, Mounting screw × 4
Option AC adapter: AD-246
The SS-9001 is a speaker selector used with the ZP-001T zone paging
module. It outputs 2 input signals to 4 different zones. The ZM-9001 is a remote control switch panel used with the M-9000. It
provides an additional 6 control inputs of amplifier expansion, and can be
mounted in an American standard
1-gang electrical box in the wall.
The ZM-9002 is a remote control switch/volume panel used with the
M-9000. It adds 4 amplifier control inputs and 1 remote volume control,
and can be mounted in an American Standard 1-gang electrical box in
the wall. The AN-9001 is an electret condenser microphone designed for ambient
noise sensing. It is used in conjunction with the AN-001T Ambient Noise
control module in the M-9000. It can be mounted in an American
Standard 1-gang electrical box in the ceiling or wall.