Ii. engine with choke, Figure 23. optional fuel valve positions, Figure 24. typical engine symbols – Tecumseh H30-40 User Manual
Page 12: High speed, Low speed, Stop, Figure 25. engine speed control levers

Page 10
Four-Cycle Engine • Horizontal Crankshaft • Air-Cooled
181-789-14
II. Engine With Choke
1. To avoid carbon monoxide poisoning, ensure engine is
outdoors in a well-ventilated area.
2. Be sure fuel valve (optional) is open and all switches
are on. See Figure 23.
3. Move Equipment Control (see equipment manufac-
turer’s instructions) or Engine Throttle Control to
“FAST” position or “HIGH” position and set Choke Con-
trol to “FULL” position. See Figures 24, 25 and 26.
NOTES
If restarting a warm engine after a short shutdown, move
Equipment Control to “FAST” position and Choke Control to
“NO CHOKE” position. See Figures 25 and 26.
Some engines are equipped with an optional Spring Loaded
Throttle Control. This spring loaded control is used to
ensure the throttle will return to engine idle speed if it is
released or if the cable fails. The throttle control must be in
the idle position when starting engine.
Figure 23. Optional Fuel Valve Positions
Figure 24. Typical Engine Symbols
Figure 25. Engine Speed Control Levers
Fuel Tank
Fuel Valve “Open” Position Shown
Turn Valve Clockwise
To “Off” Position
STOP
STOP
SLOW
RUN
FAST CHOKE PRIMER
Remote Models
All Other Models
1. High Speed
2. Low Speed
3. Stop
1
3
2