Telenetics MIU/PowerPort Series 9.6 - Manual (Page 2)

25111 Arctic Ocean Drive
Lake Forest, CA 92630
tel. 949.455.4000 fax. 949.455.4010
www.telenetics.com
Technical
Specifications MIU/PowerPort
202T
MIU/PowerPort
2.4
MIU/PowerPort
9.6 & 9.6L
MIU/PowerPort
14.4 & 14.4L
Modem Line
Speeds:
Asynchronous
0 - 1200bps
DTE Rates: above
modem line speeds
(ie; with data
compression)
—
Standards:
Dial Up
2 / 4-W Leased Line
Bell 202T
No
Yes 1
Yes
No
Yes (Model 9.6)
Yes (Model 9.6L 2 )
Yes (Model 14.4)
Yes (Model 14.4L 2 )
V.22bis, V.22
Bell 212A
Bell 103
V.22bis, V.22
Bell 212A
Bell 103
V.32bis, V.32
V.22bis, V.22
Bell 212A, Bell 103
2400, 1200,
300bps
—
19200, 9600,
4800bps
57.6, 38.4,
19.2kbps
2400, 1200,
300bps
14400, 9600, 4800,
2400, 1200, 300bps
Configuration Dip Switch
Digital Port RS232 with DB25 Female Connector
Analog Port RJ-11 Modular Jack
Case Size 5-3/8" x 4" x 1-3/8"
Certifications FCC Part 68 Class A; Industry Canada Certified
Environment -40°C to +85°C, 0 to 95% humidity (non-condensing)
Power Requirement
+5VDC ±5% in through Pin 10 on the DB25 Data Port
(Option: 7-16VDC in through Pin 10 on the DB25 Data Port. Please Specify -PO.)
The modem can also be powered from an
optional 120VAC wall transformer model WT/120-9VA.
Hayes™ Extended AT Command Set
Error Correction/
Data Compression
None None
MNP 2, 4, 5 & 10
V.42, V.42bis
Current
Consumption
128mA @ +5VDC
71mA @ 12VDC
64mA @ +5VDC
35mA @ 12VDC 100mA @ +5VDC
56mA @ 12VDC
219mA @ +5VDC
123mA @ 12VDC
Surge Protection
(Analog Port)
3.75kVac 5kVac 5kVac 3.75kVac
Important Notes regarding leased line operation: 1 Bell202T is half or full duplex, suitable for point-to-point and
multipoint applications. 2 The standard 9.6L and 14.4L models are 4-wire, full or half duplex, point-to-point only. 2-wire,
full duplex, point-to-point available on special order.
Dial up modems can be factory set to automatically fall into “Power Down” mode after 45 seconds of
inactivity. Draws <0.2mA in power down mode. Powers back up on receipt of DTR signal or incoming call.
Telenetics is a registered trademark of Telenetics Corporation. All other trademarks are the property
of their respective holders. ©2000 Telenetics Corporation. All rights reserved.
Document #0004 0700