Targus Multi-Channel Mouse - Manual (Page 5)

5
Targus Wireless Multi-Channel Mouse
After your computer detects the USB receiver and the driver
software is installed, you must establish a communications link
between the mouse and its receiver BEFORE you can use the
mouse. To establish this link, you need to set the identification
code so that the mouse works properly. To do this:
1 Press and release the link button on the receiver.
Sample receiver
The receiver’s status light blinks when the receiver is
activated.
2 Press and release the connect button, located on the bottom
of the mouse.
Sample mouse bottom
The mouse’s light emitter diode (LED) stops glowing when
you press the connect button and resumes glowing when the
button is released.
When the communication link is established, the receiver’s
status light turns off.
You are now ready to use the mouse.
Link button
Connect button