Toshiba W-705 - Manual (Page 29)

2 9
RECORDING
If a power failure occurs during the
timer program recording (including
VCR Plus+
® system recording (page
32))
• When a power failure has occurred, “- -:- -”
appears in the VCR display. Since the
programmed contents have been cleared,
reset the clock and timer programming.
• When power has failed for a short time, the
colon of the current time display blinks. The
programmed contents are not affected. Reset
the clock.
Overlaps of the programs
If two timer programs overlap, the recording start
time of program 2 has priority over the recording
off time of program 1.
Program 1
(Start time)
Program 2
(Start time)
Overlapped portion (not recorded)
Confirming the timer programs
(in the timer standby mode)
Press PROG.
The screen for confirming will appear.
After about 30 seconds, the screen disappears.
Changing/cancelling the timer
programs
1) If the TIMER indicator is lit, press both TIMER
to turn it off, and then turn the VCR on by
pressing
VCR POWER.
2) With steps 2 to 9 , change the items.
To cancel a program, select the program you
want to cancel in step
4 , and press CANCEL.
The line is then cleared.
3) Press both TIMER to return to the timer
standby mode.
Recording or playback in the timer
standby mode
First press both TIMER to release the timer
standby mode, and then press VCR POWER to
turn on the VCR. The VCR will be available for
use.
• Be sure to press both
TIMER again to return
the VCR to the timer standby mode after you
are finished.
Error indication
The “E” (Error) indicator appears in the VCR
display if you press both
TIMER when:
–– a cassette is not loaded.
–– the loaded cassette has no safety tab.
–– no timer program is set.
In these cases, a recording can not be made.
PROG
– – – / – – – : – – – : – – –
– – – / – – – : – – – : – – –
– – – / – – – : – – – : – – –
– – – / – – – : – – – : – – –
– – – / – – – : – – – : – – –
25 8 / 30 9 : 30 10 : 00
E D: n
O n CH DATE OFF D P S
PM PM SP
PROGRAM SET UP PRESET