Tripp Lite B130-101-WP - Manual (Page 5)

5
Note: You should test to make sure the entire installation works properly before pulling
cables through ceiling/walls.
1 Connect the Male end of the included VGA splitter cable to the HD15
port on the source computer.
2 Connect one of the Female connectors on the included VGA splitter
cable to the HD15 port on the local unit.
3 (Optional) Connect a local monitor to the remaining Female connector
on the included VGA splitter cable.
4 Connect the external power supply to the power jack on the local unit
and plug it into an appropriate power source.
5 Connect the 110 Punchdown Connector on the local unit to the 110
Punchdown Connector on the remote unit using Cat5/5e/6 cable.
6 Connect the HD15 port on the remote unit to a monitor.
7 Turn the display(s) on first.
8 Turn on the computer.
9 If the video on your monitor is either too dark or too light, use the Gain
Adjustment on the remote unit.
10 If the video on your monitor is fuzzy, or shows a ghosting effect, use the
EQ Adjustment on the remote unit.
Installation
1
2
3
4
5
6
200908075 93-2928.indb 5 9/22/2009 11:27:44 AM