Gas connections, Levelling – Tricity Bendix SG 210 User Manual

Page 21

Levelling

Fix the support with two legs with the washer
and nuts, delivered with the cooker, see the
figure.
• Unscrew the legs as far as possible (approx.

16mm from fully screwed in).

• Place the plinth (pos.3) so that the springs

(pos.2) reach the threaded area of the legs
and the clamp of the plinth (pos.4) is in front
of the holes (pos.5) on the under side of the
structure.

• Push the plinth towards the appliance with

both hands until the springs fasten on the
legs and the clamps go into the
corresponding holes.

• Adjust the legs as necessary.

GAS CONNECTIONS

Your cooker is delivered adjusted for the kind of
gas stated on the rating plate.

If the appliance is supplied with natural gas and
the pressure for natural gas is 20mbar, the
following methods of connection to the gas
supply must be used:

Right Hand Connection (from front)
Ensure that the rubber hose is not in contact
with any part of the shaded area shown in the
diagram and that the loop of the hose when
connected is not in contact with the floor when
the appliance is in position.

Left Hand Connection (from front)
Ensure that the rubber hose is not in contact
with any part of the shaded area shown in the
diagram and the hose is retained in the clamp
provided, it will be necessary to fit the maximum
length hose when using this method.

BACK OF THE COOKER

power cord

connection

of flexible

hose

clamps