Thermador Coffeemaker - Manual (Page 2)

2
Connection
d CAUTION
The appliance is supplied with a fitted plug and may be
connected to a correctly installed earthed socket only
(NEMA 5Ć15R, 125 V, 15 A, 2 Pole 3 wire Grounding).
Only an electrician may fit a socket or replace the power
cord in consideration of the relevant regulations.
Only an appliance which has been correctly installed
according to these installation instructions can be used
safely.
Attach loose cabinets to the wall with a conventional
bracket.
Included in standard delivery
Fig. 1
a Chassis (with telescopic slides)
b Support plate with appliance and front panel
c Wood screws (6x)
d SelfĆtapping screws (2x)
e Bar
f Fastening screws (2x)
g Cable holder
Installing the appliance
d CAUTION d
To avoid overheating and burn hazard all
specified clearances must be observed.
Fig. 2
The builtĆin unit must not have a rear panel behind the
appliance.
There must be a gap of at least 1
3 /
4
inches (45 mm)
between the wall and base of the unit or the rear panel
of the unit situated above.
The ventilation slots and intake openings must not be
covered.
Also follow the installation instructions for the appliance
situated above or below.
If installing the appliance above a warming drawer, the
height of the recess must be 27 7 /
16
inches (590 mm).
If the appliance is installed directly under a décor panel,
ensure that there is a ventilation slot of at least
31 square inches (200 cm 2 ).
The ideal installation height for the fully automatic espresso
machine, measured from the floor to the lower edge of the
appliance, is 37 1 /
4
inches (950 mm).
S
First unpack all parts according to the instructions and
check for damage in transit.
Do not switch on a damaged appliance.
Fig. 3
S Place the bar e under the top of the chassis a and screw
on with the screws f.
Fig. 4
S Then attach the chassis a, centred and flush at the front,
with the enclosed 6 screws c.
Fig. 5
S
Pull out both telescopic slides.
S Place the support plate b with the appliance on the two
telescopic slides.
Secure with the preĆassembled screws d.
S Insert the plug and clamp the coiled cable in the cable
holder g.
en