7technical data 8 cleaning – Topcom SMC-3000 User Manual
Page 6
6TOPCOM SMC-3000
TOPCOM SMC-3000
6.4
Rolling massage
During swing rolling, the massage heads will swing from bottom to top and reverse.
•
Press the relevant rolling massage button
to select either:
– “Full” to enjoy a full back rolling massage.
– “Upper” to enjoy only the upper back rolling massage.
– “Lower” to select the lower back rolling massage.
6.5
Width adjustment
During rolling massage, you can change the distance between the massage heads.
With each press on the width button
, the massage heads will move to the next available position.
6.6
Shiatsu massage
The SCM-3000 Shiatsu massage cushion has rotating massage heads which imitates the pressure and
kneading motions of a real Shiatsu massage.
Press the relevant shiatsu massage button
to select either:
•
“Full” to enjoy a full back shiatsu massage.
•
“Upper” to enjoy only the upper back shiatsu massage.
•
“Lower” to select the lower back shiatsu massage.
6.7
Spot massage (Shiatsu)
•
Press the spot massage up
or down
button to stop the kneading massage at a certain point.
•
Hold the up
or down
button to move the massage mechanism up or down.
•
Release the button when you have reached the desired massage point.
7
Technical data
8
Cleaning
•
Disconnect the device and allow it to cool down.
•
Clean it with a soft cloth or slightly damp sponge.
•
Never allow that water or any other liquid enters the device or accessories.
•
Never use abrasive cleaners, brushes, gasoline, kerosene, glass polish or paint thinner to clean.
Dimensions (W/H/D)
Weight
Power supply unit voltage:
– Input:
– Output:
710 x 165 x 485mm
4.5Kg
100-240 V/AC/50-60 Hz
DC 12V/3A
V
VI
IX
III
IV
III
IV
There is a 15-minute auto shut off on the unit for your safety.
When the massager is switched off, the massage mechanism will always return to its
lowest position.
When selecting the seat vibration together with the back massage, there will be a
slight decrease of the vibration strenght. This adjustment is perfectly normal and
should not be interpreted as a defect.