Technicolor - Thomson RP5430 - Manual (Page 51)

Operating the Menu System Operator's Manual LDK 200 Triax 6-5
Security Menu for Owner's Access
The Security menu provides restricted access to
special set-up and security features of the camera.
Access to this menu requires the owner's unique
smart card for the camera or the PIN code that has
been set for the camera.
Note: An owner card is linked to the serial number of
the camera and is unique to that camera. It
cannot be used as an owner card for another
camera.
Inserting the owner card into the camera gives direct
access to the security menu. If you select the Security
menu without this card inserted, you must enter the
correct PIN code to gain access to the Security menu.
User Levels
The installed user level function in the Security menu
restricts access, in varying degrees, to the operational
controls of the camera. There are four user levels and
a service level: user0, user1, user2, user3 and service.
The purpose of the user levels is to restrict the set of
functions which can be changed by whoever is using
the camera. In this way a more centralized and
uniform control can be achieved and the danger of the
camera operator accidentally changing critical
functions while shooting is reduced.
User level 0 is a special protection level which locks
most of the operational controls of the camera. Use
this level to ensure that a camera that has been set-
up is not tampered with. User level 0 is not normally
used for operational purposes.
The service level gives access to all settings. Enter
the PIN code or insert the owner card to access the
service level. Leave the service level by removing the
owner card or if the access is provided by the PIN
code by switching the power to the camera off and on.
The appendix indicates which functions are available
at each user level.
Run Hours
This sub-menu allows the date and time to be set and
allows the running time of the camera to be viewed for
the last 30 days.
Systems Menu
PIN Code
The PIN code of the camera can be viewed and
changed in the Security menu.
The camera's PIN code when it leaves the factory is
set to 0000. It is strongly advised that this code be
changed by the owner on receipt of the camera. This
ensures added protection against unaurthorised
access to the Security menu.
Standard customer file
The green button on the side of the camera recalls the
standard scene file. This file contains standard
parameters for the picture performance.
A standard operator's file can be recalled via the Files
menu. This file contains parameters for the set-up of
the camera.
A customer standard file can be defined for the
standard scene file and for the standard operator's
file.
The contents of the customer files for both these
standard files is stored via the security menu. The
selection of a factory defined or a customer defined
file for use as a standard file is also made in this menu.