Tripp Lite DUAL CAT5 B125-150 - Manual (Page 3)

3
1 Connect the HDMI source to the HDMI input on the local transmitter unit.
2 Connect the TMDS RJ45 port on the local transmitter to the TMDS
RJ45 port on the remote receiver using Cat5e/6 cable.
Note: See the installation diagrams for maximum extension
distance at 1080p (24 Hz) / 1080i (60 Hz) video resolutions.
3 Connect the DDC RJ45 port on the local transmitter to the DDC
RJ45 port on the remote receiver using Cat5e/6 cable.
Note: See the installation diagrams for maximum extension
distance at 1080p (24 Hz) / 1080i (60 Hz) video resolutions.
4 Connect the HDMI output on the remote receiver to the HDMI monitor.
5 Connect the external power supply to the remote receiver, and then
plug it into a Tripp Lite Surge Suppressor, Uninterruptible Power Supply
(UPS), or Power Distribution Unit (PDU). The Green LED on the remote
unit will illuminate to indicate that power is being received.
6 Turn on the power to the HDMI source.
Note: The Red LED on the Remote Receiver unit will illuminate only
if a working signal is NOT being received. The unit is functioning
properly when this LED is not illuminated.
Installation and Operation
201112150-93-3153.indd 3 1/4/2012 11:49:36 AM