Targus wireless mouse - Manual (Page 9)

9
Targus Rechargeable 5-Button Wireless Mouse
2 Connect the other end to the mouse; the charger
connector is located on the front tip of the mouse.
3 Alternatively, you can connect the receiver to the
supplied extension seat and plug the extension seat
cable to the USB port on your computer.
NOTE: To continuously charge the mouse via the USB
charge cable, your computer must be on and awake.
For best results, turn off your computer’s power
management feature while charging the mouse.
Establishing a Communications
Link
The mouse has 256 identification codes that allow the
mouse and its receiver to operate without interference from
other radio frequency devices.
After your computer detects the USB receiver and the
driver software is installed, you must establish a
communications link between the mouse and its receiver
BEFORE you can use the mouse. To establish this link, you
need to set the identification code so that the mouse works
properly.
AMW06EU.book Page 9 Tuesday, December 20, 2005 12:55 PM