Tektronix P6723 - Manual (Page 11)

P6701B, P6703B, and P6723 Service Manual 1
P6701B and P6703B Specifications
The specifications in Tables 1 through 3 apply to a P6701B or P6703B O/E
converter. The converter must have a warm-up period of at least 20 minutes and
be in an environment that does not exceed the limits described in Table 1.
Specifications for the P6701B and P6703B O/E converters fall into three
categories: warranted, typical, and nominal characteristics.
Warranted Characteristics
Warranted characteristics (Table 1) describes guaranteed performance within
tolerance limits or certain type-tested requirements. Warranted characteristics
that have checks in the Performance Verification section of the service manual
(070-9892-XX) are marked with the
n symbol.
Table 1: P6701B and P6703B warranted electrical characteristics
DC optical input dynamic range DC electrical out will meet conversion gain specifications up to
11 mW (0 dBm) peak optical power input
Absolute maximum non-destructive optical input 10 mW average power; 20 mW peak power
n DC conversion gain
P6701B: 1 V/mW
± 8% at DC, 780 nm
P6703B: 1 V/mW
± 8% at DC, 1310 nm
n AC conversion gain
P6701B: 1 V/mW
± 8%, with ≤ 100 W
P-P
optical modulation,
780 nm
P6703B: 1 V/mW
± 8%, with ≤ 100 W
P-P
optical modulation,
1310 nm
n Output zero ≤ ± 1 mV into 50 Ω, 20 to 25_ C
n Noise equivalent power
(with 1 GHz low-pass filter)
P6701B:
≤ 0.87 W
RMS
P6703B:
≤ 0.59 W
RMS
( ≤ 28 pWፒ Hz
Ꭹ )
( ≤ 19 pWፒ Hz
Ꭹ )
Output impedance 50
Ω ± 10%
Temperature Operating: 0 to +50 _ C
Nonoperating: --40 to +71
_ C