Troy-Bilt 13045 - Manual (Page 7)

7
Figure 7
Safety Ignition Key
The ignition key must be inserted in the switch in order
for the engine to start. Remove the ignition key when
the snow thrower is not in use.
NOTE: Do NOT “turn” the ignition key in an attempt to
start the engine.
Shift Lever
The shift lever is located in the center of the handle
panel and is used to determine ground speed and
direction of travel. It can be moved into any of eight
positions. See Figure 7.
IMPORTANT: Always release traction the control before
changing speeds.
Forward
Your snow thrower has six forward (F) speeds.
Position number one (1) is the slowest and position
number six (6) is the fastest.
Reverse
Your snow thrower has two reverse (R) speeds. R1 is
the slower, while R2 is the faster of the two.
Traction Control / Auger Control Lock
The traction control is located on the right handle.
Squeeze the traction control to engage the wheel drive.
Release to stop. See Figure 7.
This same lever also locks the auger control lock, so
you can operate the chute crank without interrupting the
snow throwing process. If the auger control is engaged
simultaneously with the traction control, the operator
can release the auger control (on the left handle) and
the augers will remain engaged. Release the traction
control to stop both the augers and wheel drive (the
auger control must also be released).
IMPORTANT: ALWAYS release the traction control
before moving the shift lever. Failure to do so will result
in premature wear to the drive system’s friction wheel.
Auger Control
The auger control is located on the left handle.
Squeeze the auger control to engage the augers.
Release to stop the snow throwing action. The traction
control must also be released in order to stop the auger.
IMPORTANT: Refer to Auger Control Test on page 9 prior to
operating your snow thrower. Read and follow all
instructions carefully and perform all adjustments to
verify your snow thrower is operating safely and
properly.
Chute Directional Control
The chute directional control is located on left hand side
of the snow thrower.To change the direction which
snow is thrown, rotate chute directional control as
follows:
• Clockwise to discharge to the left.
• Counterclockwise to discharge to the right.
Headlights
When properly connected, both headlights illuminate
whenever the engine is running.
Fuel Tank
Auger
Skid Shoe
Switch
Box
Electric
Starter
Button
Recoil
Starter
Handle
Primer
Choke
Safety Ignition Key
Throttle Control
Shift Lever
Traction Control /
Headlights
Discharge
Auger Control
Left Wheel Steering Control
Chute Tilt Control
Chute Directional Control
Auger Control Lock
Chute
Chute
Clean-out Tool
Right Wheel Steering Control