QSC Audio 6.0 II - Manual (Page 17)

17
CONNECTIONS- Outputs: Binding Posts
Connecting the Outputs to the Speakers
Use either the binding post or the Speakon™ output connections. Binding posts are covered on this
page, Speakons on the following page. Note that the PL6.0 II does not support Bridge mode output
from the Speakons (see page 11).
There are two basic speaker connection configurations for the PL6.0 II. Stereo and Parallel operating
modes use two separate output channel connections. Bridge mode uses only one output channel
connection.
Refer to the chart below for connection diagrams. Mode Switch position is shown for reference.
Speakon™ pinout is provided on the following page.
Do not use less than 4-ohm loads in Bridge mode! Note polarity of connections
for Bridge mode. Speakon connections do not support Bridge mode.
Do not use banana-type plugs for connecting to binding posts. They will fail at
the high power levels of this amplifier!