Quatech Asynchronous Communications Adapter DSC-200/300 - Manual (Page 13)

3 Hardware Installation
1. Turn off the power of the computer system in which the DSC-200/300 is to be
installed.
2. Remove the system cover according to the instructions provided by the
computer manufacturer.
3. Make any desired optional jumper setting changes.
4. Install the DSC-200/300 in any empty PCI expansion slot. The board should be
secured by installing the Option Retaining Bracket (ORB) screw.
5. Replace the system cover according to the instructions provided by the
computer manufacturer.
6. Attach and secure the cable connectors to the desired equipment.
7. Turn on the power of the computer system.
The output of the DSC-200/300 is two female 9-pin D-connectors.
J10
J11
J12
J13
X2
X4
X8
SPAD
Clock multiplier/
scratchpad select
Termination select
Interface configuration
J1
J2
J3
J4
J5
J6
J7
J8
port 1
port 2
Serial
Port
2
Serial
Port
1
Figure 6 --- Jumper/connector locations
Quatech DSC-200/300 User's Manual 13