Quatech DSCLP-100 - Manual (Page 9)

3 Hardware Installation
1. Turn off the power of the computer system in which the DSCLP-100 is to
be installed.
2. Remove the system cover according to the instructions provided by the
computer manufacturer.
3. Make any desired optional jumper setting changes.
4. Install the DSCLP-100 in any empty PCI expansion slot. The board
should be secured by installing the Option Retaining Bracket (ORB)
screw.
5. Replace the system cover according to the instructions provided by the
computer manufacturer.
6. Attach and secure the cable connectors to the desired equipment.
7. Turn on the power of the computer system.
The output of the DSCLP-100 is a 25-pin D-connector. A cable is
provided to convert the D-25 into two standard male D-9 connectors with all
control signals provided to each port (RTS, DTR, CTS, DSR, DCD, and RI).
The output of the SSCLP-100 is one standard male D-9 connector.
J 2
J 4
J 5 X2
X4
SPAD
Clock multiplier/
scratchpad select
Figure 5 --- Jumper/connector locations
9 DSCLP/SSCLP-100 User's Manual