SEVERIN TO 2036 User Manual
Page 10

close to or underneath any wall-cupboards 
or hanging objects such as curtains or any 
infl ammable materials.
During operation, the appliance must 
z
be placed on a heat-resistant surface, 
impervious to splashes and stains. Do 
not position the appliance on or near 
hot surfaces, open fl ames or infl ammable 
vapours.
Caution:
z
the pizza stone becomes very
hot during use, and will only cool down 
very slowly aft er the appliance has been 
switched off and disconnected from mains 
power. Th
ere is a severe danger of burns in
any case of contact.
Always let the pizza stone cool down 
z
completely before it is removed from the 
appliance.
Caution:
z
do not place aluminium foil or
anything similar between the grill rack and 
the pizza stone. Place the stone directly 
onto the rack.
Do not allow the power cord to touch any 
z
hot parts of the appliance.
Do not let the power cord hang free.
z
Always switch off and remove the plug
z
from the wall socket aft er use, as well as
in cases of malfunction, and
-
during cleaning.
-
When removing the plug from the wall 
z
socket, never pull on the power cord; 
always grip the plug itself.
No responsibility is accepted if damage 
z
results from improper use, or if these 
instructions are not complied with. 
Th
is appliance is intended for domestic use
z
only and not for commercial applications.
In order to comply with safety regulations 
z
and to avoid hazards, repairs of electrical 
appliances must be carried out by qualifi ed 
personnel, including the replacement 
of the power cord. If repairs are needed, 
please send the appliance to one of our 
customer service departments. Th
e
address can be found in the appendix to 
this manual.
Temperature control
With the temperature control knob, the 
temperature can be set to the desired level. 
5-position switch settings
z Both heating elements and rotating spit
switched off .
Upper heat
Upper heat with rotating spit
Upper heat and lower heat
Lower heat
Th
e heating elements will only be switched
on aft er the timer is activated.
Timer
By using the timer, the cooking time can be 
selected up to a maximum of 60 minutes. 
To set a time of less than 10 minutes, turn the 
timer to a somewhat higher setting fi rst and 
then slowly turn it back to the desired time 
setting. Aft er the pre-programmed time has 
elapsed, an acoustic signal indicates that the 
heating elements are switched off . To switch 
off the entire appliance, the heating elements 
must be switched off as well.
Indicator lamp
Th
e indicator lamp lights up when the
appliance is switched on. It goes out once the 
pre-programmed time has elapsed, or if the 
switch is turned back to position 0.
Hot-air convection 
Th
e hot-air convection fan is activated
automatically whenever the heating elements 
are switched on.
Rotating spit
When using the rotating spit, only the upper 
heating function is used. 
Before the spit is used, always ensure that
–
the baking tray is properly inserted into 
any of the guide rails.
When the food to be cooked is put onto 
z
the spit, make sure that it cannot come 
into contact with either the upper heating 
elements or the baking tray; ensure 
10
