Introduction – QSC Audio DSP-3 User Manual
Page 13
Section 1:
Introduction-
Basic Connector & Indicator Descriptions
13
REAR PANEL
OVERALL
DATAPORT (unlabeled)- This is the “output”
DataPort.
If the DSP-3 is directly mounted on a 2-RU QSC
DataPort equipped amplifier, this connector plugs
into the amplifier’s DataPort connector.
If used with 3-RU QSC DataPort equipped amplifi-
ers, the DSP-3 will need to be remotely mounted
and a male-female DataPort cable used to inter-
connect the amp & DSP-3.
If used with a non-DataPort amp (QSC or other),
this connector will not be used.
See also other documents in the category QSC Audio Acoustics:
- NAC-100 (20 pages)
- ACE 570 (2 pages)
- BASIS 914LZ (28 pages)
- SC-312X (26 pages)
- SC-413H (2 pages)
- HPR181i (116 pages)
- AD-S32T (9 pages)
- PB2082-i (20 pages)
- MD-F122/124r (4 pages)
- SC-312 (2 pages)
- MD-FP122/94r (12 pages)
- WL3082 (1 page)
- 1250 WR (2 pages)
- MD-SP215 (2 pages)
- SC-412 (2 pages)
- YOKE MOUNT BRACKETS YM-300 (6 pages)
- DSP-3 (4 pages)
- DSP 322UA (20 pages)
- AD-S82 (2 pages)
- MD-LP115 (2 pages)
- 522AA (26 pages)
- SC-322 (42 pages)
- 922dz (2 pages)
- SR-46 (10 pages)
- AD-S282HT (16 pages)
- HPR151W (20 pages)
- SC-324 (2 pages)
- WideLine Array (2 pages)
- MD-SP218 (56 pages)
- LF-3115 (2 pages)
- LF-4215 (4 pages)
- ALK-MD2 (1 page)
- MD-FP152/66 (4 pages)
- WL2082-1 (2 pages)
- WL2102-w (14 pages)
- LF-4315 (20 pages)
- DSP0002 (4 pages)
- Network Audio Systems (6 pages)
- ISIS Series Loudspeaker I-84H (2 pages)
- SR-26 (10 pages)
- SC-423 (2 pages)
- 8X8 SIGNAL PROCESSOR DSP 322UA (20 pages)
- SR-18 (10 pages)
- SC-322X (27 pages)