Oricom AM100 - Manual (Page 12)

11
6.2 Turning Your System On
If you forget to turn your system on, you can phone in from a
remote location and turn it on automatically.
1.
Call your telephone number.
2. The system answers after 10 rings. After the beep, enter
your 3-digit security code.
3. After the second beep, press 9# then hang up. Subsequent
messages will be recorded.
6.3 Remote Commands
If the correct code was accessed, you hear two beeps.
Option
Press
Play messages in mailbox 1 1 #
Play messages in mailbox 2 2 #
Delete all old messages 3 #
(all messages must be played back)
Record new outgoing message 7 #
(Press 7# again to stop recording outgoing message)
Turn system off/on 9 #
Monitor the room 0 #
When you press 1# to play messages in mailbox 1, or 2# to play
messages in mailbox 2 (during playback), you can then press
the following keys to get these remote functions.
Option
Press
Erase current message 3 #
Repeat previous message 6 #
Skip to next message 7 #
Repeat current message 8 #
Stop message playback # #
After all your messages have been played, you hear two short
beeps. You have 20 seconds to access the menu again,
otherwise, the unit disconnects automatically.
Note: When you are in remote playback, if there are new
messages in mailbox 1 or mailbox 2, enter the instruction “1#”
or “2#”, only new messages will be played back to you; if there
are no new messages in mailbox 1 or mailbox 2, enter the
instruction “1#” or “2#”, all messages will be played back to you.