OxiBrands 1/4" 18 Gauge Crown Air Stapler 68018 - Manual (Page 13)

Page 13 For technical questions, please call 1-800-444-3353. SKU 68018
USER-MAINTENANCE
Procedures not specifically
explained in this manual must
be performed only by a
qualified technician.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL OPERATION,
BEFORE ANY MAINTENANCE OR
REPAIRS ARE DONE (including
clearing jams):
• Wear ANSI-approved safety
goggles with side shields. Other
people in the work area must also
wear ANSI-approved impact safety
goggles with side shields.
• Release the Trigger.
• Detach the air supply.
• Attempt to fire the Tool into a
piece of scrap wood to ensure
that it is disconnected and is
incapable of firing any fasteners.
• Empty the staples from the Nail
Guide Frame and Magazine and
leave it open during service.
TO PREVENT SERIOUS INJURY
FROM TOOL FAILURE: Do not
use damaged equipment. If
abnormal noise, vibration, or
leaking air is detected, correct
problem before further use.
TO PREVENT EXPLOSION:
Lubricate only with specified
lubricants. Lubricate the air inlet
using only pneumatic tool oil.
Lubricate the internal mechanism
using only white lithium grease.
Other lubricants may damage the
mechanism and may be highly
flammable, causing an explosion.
Note: These procedures are in addition to
the regular checks and maintenance
explained as part of the regular operation
of the air-operated tool.
Daily - Air Supply Maintenance:
Every day, perform maintenance on the
air supply according to the component
manufacturers’ instructions. The
lubricator’s oil level needs to be
maintained and the moisture filter must
be regularly drained. Performing routine
maintenance on the air supply will allow
the tool to operate more safely and will
also reduce wear on the tool.
Clearing Jams
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL OPERATION,
BEFORE ANY MAINTENANCE OR
REPAIRS ARE DONE (including
clearing jams):
• Wear ANSI-approved safety
goggles with side shields. Other
people in the work area must also
wear ANSI-approved impact safety
goggles with side shields.
• Release the Trigger.
• Detach the air supply.
• Attempt to fire the Tool into a
piece of scrap wood to ensure
that it is disconnected and is
incapable of firing any fasteners.
• Empty the Nail Guide Frame and
leave it open during service.
1. If a fastener is jammed in the discharge
area, disconnect tool from air hose,
press down on the Latch and pull back
on Nail Guide Frame.
2. Empty Magazine (49) of staples, release
any built-up air pressure, and leave the
Magazine open.
User-Maintenance Instructions