Orion Car Audio 200 - Manual (Page 39)

Distorted output Internal crossover not set properly Readjust crossovers. Refer to the Internal Crossover section of this
for speakers manual for detailed instructions.
Speakers are blown Check system with know working speakers and fix or replace as needed.
Poor bass response Speakers wired with wrong polarity Check speaker polarity and fix as needed.
causing cancellation at low frequency
Crossover set incorrectly Reset crossovers. Refer to the Internal Crossover section of this manual
for detailed instructions.
Impedance load at amplifier is too low Check speaker impedance load, if below 2 Ω stereo or 4 Ω mono
rewire speakers to achieve a higher impedance.
Battery fuse Short in power wire or incorrect Check power and ground connections and fix or repair as needed.
blowing power connections.
Fuse used is smaller than recommended Replace with proper fuse size.
Too much current being drawn Check speaker impedance load, if below 2
Ω
stereo or 4
Ω
mono
rewire speakers to achieve a high impedance.
Check power and ground connections and fix or repair as needed.
Amplifier fuse Too much current being drawn Check speaker impedance load, if below 2
Ω
stereo or 4
Ω
mono rewire
blowing speakers to achieve a high impedance and replace with recommended
size fuse.
Check power and ground connections and fix or repair as needed.
Fuse used is smaller than recommended Replace with proper fuse size.
Impedance load at amplifier too low Check speaker impedance load. If below 2 Ω stereo or 4 Ω mono, rewire
speakers to achieve a higher impedance.
Speaker is blown with shorted outputs Check system with known working speakers and fix or replace as needed
page 37