Changing the input display, Basic operations —continued – Onkyo CR-325 User Manual
Page 27
27
You can choose what name is displayed when an input source is selected so that it matches the type of component that
you’ve connected to the MD/TAPE IN. When you connect an Onkyo
-capable component, it’s important that you
select the input source name that matches the type of component for
to work properly.
Input Source Name Abbreviations
Sometimes the input source name may be displayed as a
2-letter abbreviation, as per the following table.
Changing the Input Display
1
Use the INPUT [
]/[
] buttons
to select “TAPE”.
2
Press and hold the [MENU/NO]
button until “Name Select?”
appears on the display, and then
press [ENTER].
3
Use the Previous or Next
[
]/[
] button to select the
new input source name.
The input source names are selected in
the following orders:
*
When you select an input source name, you
cannot select it as the recording component
at the set timer recording.
/
MENU/NO
ENTER
INPUT
/
HOLD
MD
TAPE
VIDEO
*
DAT
*
4
Press [ENTER] to confirm your
selection.
“Complete” appears on the display.
Full name
Abbreviation
DAT
DT
MD
MD
TAPE
TP
VIDEO
VD