DAEWOO ELECTRONICS DWB-072C - Manual (Page 4)

4
INSTALLATION INSTRUCTIONS
• HOW TO REMOVE THE FRONT GRILLE
1. Pull the Air-filter out of the Front Grille.
2. Loosen screw which fasten Front Grille with driver.
3. Pull knobs out of the control.
(when the knobs are too tight to release, leave them.)
4. Disassemble Front Grille from Chassis.
– Front Grille and chassis are fixed with snap-fit.
1) Release right-lower snap-fit.
– Push the right lower side of chassis to the left, with pushing left side
of Front Grille to the right until the snap-fit is released.
2) Release left-lower snap-fit.
– Push the left-lower side of chassis to the right, with pushing right
side of Front Grille to the right until the snap-fit is released.
3) Pull lower side of the Front Grille until it is separated from the
chassis. (when knobe remain, pull Front Grille until knobs are
released from control)
4) Push base side of the Front Grille to upper side until it is separated
from the chassis.
5. After front grille is removed, remove two screws located in both side
of chassis and pull out the unit from chassis.
6. Reinstall the unit, side screws, front grille.
Push
Push
Push
Push