Nitial setting, Initial setup – Sylvania LC155SL8P User Manual

Page 12

NITIAL SETTING

Initial Setup

This section will guide you through the unit’s initial setting which includes
selecting a language for your on-screen menu and “AUTO PRESET CH”, which
automatically scans and memorizes viewable channels.

Before you begin:

Make sure if the unit is connected to antenna or cable.

After making all the necessary connections, press
[POWER] to turn on the unit.

• This operation may take a few moments.

Use [Cursor K /L] to select the on-screen language
from the choices on the right side of the TV screen.
(ENGLISH / ESPAÑOL / FRANÇAIS)

SELECT LANGUAGE
SELECCIONE EL IDIOMA
CHOISIR LA LANGUE

ENGLISH
ESPAÑOL
FRANÇAIS

SET : ENTER

AJUSTE : ENTER

VALIDER : ENTER

SELECT : K,, L

SELECCIONE : K,, L

CHOIX : K,, L

• “INITIAL SETUP“ menu on step 3 will be displayed in

the selected language after you press [ENTER].

Use [Cursor K /L] to select “AUTO PRESET CH(TV/DTV)”
for TV channels or “AUTO PRESET CH(CATV)“ for CATV
channels, then press [ENTER].

PLEASE CONNECT ANTENNA OR CABLE
OR SATELLITE TO THIS UNIT.

AUTO PRESET CH(TV/DTV)
AUTO PRESET CH(CATV)

- INITIAL SETUP -

• Scanning and memorizing the channels automatically

start.

AUTO PRESET CH(TV/DTV)

• When the scanning and memorizing are completed,

the lowest memorized channel in the broadcasting
will be displayed.

Note:

• If you connect the cable system directly, contact the CATV

installer.

• If you press [POWER] or [SETUP] during “AUTO PRESET CH”,

this setting will be canceled.

• The initial auto channel scan function can be executed for

either TV/DTV or CATV only once. If you want to scan both
TV/DTV and CATV, you need to select “CHANNEL SETUP” in
the main menu to scan and memorize other channels after
initial presetting is completed. (Refer to page 13.)

• You can cancel or exit the initial “AUTO PRESET CH” menu by

pressing [SETUP].

• When no channel can be received by “AUTO PRESET CH”,

“NO TV SIGNALS” is displayed on the TV screen.

• If there is no signal input from the antenna terminal and

no operation for several seconds after you turn on the unit,
“HELPFUL HINTS” appears. Follow the instructions listed on
the TV screen.

- HELPFUL HINTS -

1. PLEASE CHECK TO SEE IF THE

ANTENNA / CABLE / SATELLITE IS
PROPERLY CONNECTED.

2. DID YOU PERFORM “AUTO PRESET CH”?
3. PLEASE REFER TO FRONT PAGE OF THE

OWNER’S MANUAL OR REAR PANEL FOR
SUPPORT LINE INFORMATION.

These operations are accessible by remote control. Some may also be accessible by controls on the main unit.