Omron Healthcare GOSMART HJ720ITC - Manual (Page 2)

2
Step 2: Get ready to use your Pedometer with HealthVault
¾ If HealthVault Connection Center is not running on your computer, please start it and sign in to
your account. Connection Center then will open to a screen showing your device(s).
¾ Select the Omron Pedometer device picture on the left hand side of HealthVault Connection
Center
¾ If you do not see a picture of your device in Connection Center, select Set up a new device and
follow the on‐screen instructions.
Step 3: Connect your Omron Pocket Pedometer to your computer and
upload your reading to HealthVault
¾ Find the USB cable that came with your Pedometer.
¾ Plug the small end of your USB cable into the slot on your Pedometer that's marked with the
USB symbol.
¾ Plug the large end of your USB cable into your computer.
¾ The symbol “PC” will appear on the Pedometer display when the USB cable is successfully
connected to the computer.
NOTE: Do not unplug the USB connector during uploading of the measurement data.
HealthVault Connection Center will sense when your device has been connected to your computer and
will prompt you to upload your test reading.
¾ Follow the Connection Center on‐screen prompts.
You will see confirmation when your upload is complete. At that point you may unplug your Pedometer
from your computer.
To see your reading in your HealthVault account:
¾ Open your Internet browser and go to Healthvault.com. (You will be asked to sign in if you
haven't accessed your account in the past 20 minutes.)
¾ Click your Health info tab.
Whenever you have new readings from your device, you can follow the same steps to upload them to
HealthVault and better manage your health and fitness.