Omega Engineering LV860 - Manual (Page 8)

LV860 LEVEL SENSOR
4 - Connection
Check that the supply voltage corresponds with the voltage rating
shown on the system.
1. Loosen the gland (PG9) (see fig. 1) and remove it together with clamping
piece and bushing.
2. Unscrew the female plug.
3. Feed the supply cable through the gland (PG9), the clamping piece, the
bushing and the female plug.
4. Connect the cable to the terminal block (see fig. 3).
5. Connect the supply voltage before adjusting the sensor.
6. Increase the level until the front side of the sensor probe is partly covered
by the medium.
CAUTION
4