Ocean Kayak SCUPPER PRO 14561 - Manual

Ledge (for
steering track)
Ledge (for
steering track)
Notch (vertical surface for
tubing and steering lines)
Notch (vertical surface for
tubing and steering lines)
Notch (vertical surface for
tubing and steering lines)
Notch (vertical surface for
tubing and steering lines)
Rudder mount
(insert nylon sleeve)
6-inch hatch (needed
to install steering lines) BOW STERN
Scupper Pro Rudder Installation Instructions (1997 or newer models)
This kit is designed for the Scupper Pro with rudder mount and notches, first shipped October 29, 1996, serial numbers greater than XKA11274. Your Pro must
also have the front and center hatches to allow acess to the hull for rudder installation.
Parts Included:
1 rudder assembly (300386)
2 steering tracks with slides and pedals
(300107)
2 lengths of tubing (300153)
2 steering lines (300084)
1 nylon sleeve (300077)
4 long machine screws (300163)
4 well nuts (300162)
1 clam cleat (300099)
1 strap eye (300048)
2 adhesive-backed strap eyes (for 2-hatch Pro)
(300104)
4 self-tapping screws (300036
2 short machine screws (300110)
4 rubber grommets (300097)
Tools Needed:
drill
3/8” drill bit
7/16” wrench
knife
phillips screwdriver
pen or marker
hammer
small block of wood
soapy water
duct tape
stiff wire (for TW)
1
2 3
4
6
5
7
Drill Tubing Holes
1. You must first drill holes at the center of each notch (3, 4, 5, 6). Hold the drill at 90 degrees to the vertical surface
of the notch, and hold it tightly to keep the drill straight through the layer of plastic.
2. Smooth any rough patches where you have drilled. Insert each of the 4 rubber grommets into each of the drilled
notches. Tubing and steering lines will run through the kayak at these points.
Call your local dealer or Ocean Kayak if you have questions. 800-8-KAYAKS or 360-366-4003. Or e-mail [email protected].
14561