Onkyo Compact Disc Player C-7030 - Manual (Page 10)

En-
10
Getting to Know the CD Player—Continued
1 To open the battery compartment, press the
small hollow and slide open the cover.
2 Insert two batteries (R03/AAA) into the
compartment.
Carefully follow the polarity diagram (positive (+)
and negative (–) symbols) inside the battery
compartment.
Batteries are not supplied with products for China.
3 Replace the cover and slide it shut.
Notes:
• If the remote controller doesn’t work reliably, try
replacing the batteries.
• Don’t mix new and old batteries or different types of
batteries.
• If you intend not to use the remote controller for a long
time, remove the batteries to prevent damage from
leakage or corrosion.
• Expired batteries should be removed as soon as possi-
ble to prevent damage from leakage or corrosion.
When you operate the remote controller, point it at the
CD Player’s remote control sensor, as shown below.
Notes:
• The remote controller may not work reliably if the CD
Player is subjected to bright light, such as direct sun-
light or inverter-type fluorescent lights. Keep this in
mind when installing.
• If another remote controller of the same type is used in
the same room, or the CD Player is installed close to
equipment that uses infrared rays, the remote control-
ler may not work reliably.
• Don’t put anything, such as a book, on the remote con-
troller because the buttons may be pressed inadver-
tently, thereby draining the batteries.
• The remote controller may not work reliably if the CD
Player is installed in a rack behind colored glass doors.
Keep this in mind when installing.
• The remote controller will not work if there’s an
obstacle between it and CD Player’s remote control
sensor.
Installing the Batteries Aiming the Remote Controller
RC-8 22C
DIMMER DISP LAY
SEA RCH ME MO RY
SETUP
CLE AR
1 2 3 4 5 6 7 8 9 >10 0
RA NDOM REPEA T
ENTER
Ap
pro
x. 5
m
(16
ft.
)
Remote control sensor