Outdoor Gourmet M6G-124 - Manual (Page 6)

HOW TO PERFORM LEAK TEST:
Use a clean paint brush and a 50/50 solution of mild soap and water. DO NOT USE
HOUSEHOLD CLEANING AGENTS.
1. Be sure control valve on regulator is in OFF position.
2. Brush soapy solution onto connection between cylinder and regulator.
If growing bubbles appear, there is a leak. Retighten connection and repeat
steps 1 and 2.
If you cannot stop a leak, remove cylinder from regulator and check for damaged
threads, dirt and debris on regulator and cylinder.
If threads are damaged on either regulator or cylinder, DO NOT use until
replaced. Also check to see if anything is obstructing the flow of gas at regulator
and cylinder openings. Remove any obstruction that may be found and repeat leak
test.
Before lighting – DO NOT use the grill if the odor of gas is present. The pressure
regulator supplied with the unit must be used. Never substitute regulators for those
supplied with the grill. If a replacement is necessary, contact the customer service
number provided to obtain a proper replacement. Screw the propane bottle firmly into
the regulator before operating the grill.
LID MUST BE OPEN WHEN LIGHTING GRILL BURNERS
TO LIGHT GRILL BURNERS:
z Always keep your face and the body as far away from the grill as possible when
lighting.
z
Open the grill lid before lighting. Failure to open grill lid during the lighting
procedures could result in a fire or explosion that could cause serious bodily
injury, death, or property damage.
- 5 -