Oregon Scientific PS-L06U - Manual (Page 18)

EN
clears the previous measurements from the memory.
SELECT REMOTE UNIT CHANNEL
While in the Temperature / Humidity Mode, press
CHANNEL to switch between CH 1, 2, or 3, or press
and hold CHANNEL for 2 seconds to enter Auto scan
mode. If only 1 remote unit is in use, you will not be
able to change channels or Auto scan. If you select
“Auto”, the channel will change every 3 seconds. To
deactivate, press and hold CHANNEL for 2 seconds
again.
SENSOR SEARCHING
If there is no remote unit signal, the temperature and
humidity measurement will be blank. Check the remote
unit batteries, or press and hold UP and DOWN for 2
seconds to search for the remote unit(s).
NOTE Signals from household electrical appliances
such as doorbells and home security systems can cause
temporary reception failures between the indoor and
outdoor units. This is normal and does not affect the
general performance of the product. Reception will
automatically resume once the interference ends.
16
Searchin No sensor Sensor found
PS-L06_GB-final.p65 8/8/03, 12:02 PM 18