Auto channel scan, Language selection – Sylvania CR202SL8 User Manual

Page 11

WATCHING TV

INTRODUCTION

CONNECTION

INITIAL SETTING

OPTIONAL SETTING

TROUBLESHOOTING

INFORMATION

Auto Channel Scan

If you switch wires (e.g., between antenna and CATV) or if you move the TV
to a diff erent area after the initial setting, or if you recover the DTV channel
you deleted, you will need to perform auto channel scan.

Before you begin:

Make sure if the unit is connected to antenna or cable.

Press [MENU] to display the main menu.

Use [CH K/L] to select “CHANNEL SETUP”,

then press [VOL X].

e.g.) digital TV mode

VOL

- TV SETUP -

PICTURE
CHANNEL SETUP
V-CHIP SETUP
LANGUAGE [ENGLISH]
CAPTION [OFF]
DTV SETUP

Use [CH K/L] to select your desired preset type,

then press [VOL X].

e.g.) digital TV mode

VOL

- CHANNEL SETUP -

ADD/DELETE(DTV)
AUTO PRESET CH(DTV)
AUTO PRESET CH(TV/DTV)
AUTO PRESET CH(CATV)
! CATV takes approx. 50min.

• When aerial antenna is connected, select “AUTO

PRESET CH (TV)”, “AUTO PRESET CH (DTV)” or “AUTO
PRESET CH (TV/DTV)”.

• When connected to CATV, select “AUTO PRESET CH

(CATV)”.

• Auto scanning begins.

e.g.) digital TV mode

AUTO PRESET CH(DTV)

D 25

• When the scanning and memorizing are completed,

the lowest memorized channel will be displayed.

• When you selected “AUTO PRESET CH (TV/DTV)”, the

lowest memorized analog channel will be displayed
when the scanning and memorizing are completed.
If there is no analog channel, the lowest memorized
digital channel will be displayed.

Note:

• If you connect the cable system directly, contact the CATV

installer.

• If you press [POWER] or [MENU] during “AUTO PRESET CH”,

the setting will be canceled.

• When no channel can be received by “AUTO PRESET CH”, “NO

TV SIGNALS” is displayed on the TV screen.

• Channel setting will be saved even if the power fails.
• If you have Spanish or French menus and need English, press

[MENU]. Use [CH K/L] to select “IDIOMA” or “LANGAGE”.
Press [VOL X] to select “ENGLISH”. Press [MENU] to remove
the main menu.

• With regard only to the digital channel, even after the

scanning is complete if you unplug the AC power cord before
turning off the unit by pressing [POWER], the channel setting
may be lost.

Language Selection

You can choose English, Spanish, or French as your on-screen language.

Press [MENU] to display the main menu.

Use [CH K /L] to select “LANGUAGE”,
then press [VOL X] repeatedly to change the setting.

e.g.) digital TV mode

VOL

- TV SETUP -

PICTURE
CHANNEL SETUP
V-CHIP SETUP
LANGUAGE [ENGLISH]
CAPTION [OFF]
DTV SETUP

[ENGLISH]

[ESPAÑOL]

[FRANÇAIS]

Press [MENU] to exit.

P7150UT_EN.indd 11

2006/11/27 20:54:05