Onkyo SKW-204 - Manual (Page 5)

5
Controls
FRONT VIEW
A Standby/On indicator (STANDBY/ON)
This indicator lights up when the power switch is set to the ON position.
Red: The unit is in Standby mode
Green: The unit is in Operational mode
If the power is turned on, the SKW-204 automatically enters Operational mode when a
signal is input.
The SKW-204 automatically returns to Standby mode when no signal has been input
for a while.
REAR PANEL
B POWER switch
Press this switch to the ON position to turn on the
power. Press it to the OFF position to turn off the
power.
C FREQUENCY knob
Use this knob to select the high-frequency range at
which to cut off the signal to the subwoofer.
You can select any frequency between 50 Hz and
200 Hz, depending on the characteristics of the
speaker system.
D PHASE switch
Use this switch to reverse the phase of the SKW-
204. Normally, set the switch to the “NOR” posi-
tion. Depending on the connected speakers or the
installation environment of the SKW-204 however,
the “REV” position may result in better sound.
Select the switch position that produces a louder
bass sound.
E OUTPUT LEVEL knob
Use this knob to adjust the volume of the sub-
woofer.
F LINE INPUT jack
Connect this jack to the SUBWOOFER PREOUT
jacks on the amplifier etc.
G VOLTAGE SELECTOR (Only some models)
This voltage selector provides compatibility with
power systems around the world.
Note:
The auto standby function engages if the input signal
level is constant. If the auto standby function does not
operate properly, try slightly increasing (or decreasing)
the subwoofer output level of the receiver.
1
5 6
3 2 7 4
To AC outlet
(Only some models)
North American Model Other Models
To AC outlet