Orion LBI-38888K - Manual (Page 50)

50
Exiting Data Calls
Under normal conditions, the radio enters the scan lockout mode and
returns to the control channel after completion of a data call (transmit or
receive). If, during a data call, one of the following conditions occurs, the
data call is immediately terminated and the radio performs the desired
function:
•
PTT activated.
•
PTT in Public Address mode.
•
Emergency declared by pressing the pre-programmed emergency
button.
•
A group or system change.
Scan Lockout Mode
Following the transmission or reception of a data call, if scan is enabled,
scanning will stop temporarily (duration pre-programmed). During this time
the scan LED will flash to indicate that scan is enabled but temporarily
suspended. This mode is normally exited when the pre-programmed time
expires; however, the following actions will terminate the scan lockout
mode before the timeout is completed.
•
The c (System Model) or C (Scan Model) button is pressed.
•
PTT is pressed.
•
A group or system change.
•
Entering phone call mode
•
Entering individual call mode.
•
A new emergency assignment has been received.
•
PTT pressed in Public Address Mode.
•
An emergency declared or cleared.
•
Microphone removed from hookswitch (OFF-hook).
•
Receiving an individual or phone call.
•
Receiving Agency, Fleet or System All Call.
•
Pressing the k button to turn scan ON or OFF.