Oreck HEATWISE HW1000P - Manual (Page 7)

4
Operation
Turning Power On
1. Press the Power button on the left side of the Control Panel.
The heater’s quartz heating elements will light up inside the
heater.
2. After a few minutes, once the air within the heater is warm,
the heater fan (some models have 2) will begin to operate.
Turning Power Off
1. Press the Power button located on the left side of the Control
Panel.
2. The sound of the heater fan will continue until the heat
has been completely vented, thus protecting the unit and
preventing waste by cycling the remaining heat into the
room. (DO NOT unplug the heater until the sound of the fan
has stopped. Doing so may cause damage to the unit.)
Setting the Temperature
This feature allows you to set the temperature measured by the
units thermostat.
1. Press the Temperature (TEMP) Button on the Control Panel;
the Set Temp Indicator will illuminate and the temperature
display will flash.
2. Use the Up and Down buttons to select the temperature and
press Enter.
3. The Set Temp light will turn off and the temperature is now set.
Setting the Timer
This feature allows you to set a future time for the heater to
turn itself ON. For example, if you set the time for 1 hour, the
heater will turn ON in 1 hour.
1.
Turn the Power OFF (heater must be powered OFF to use
the timer feature).
DELAY START
SET TEMP
INFRARED-ON
DELAY START
SET TEMP
INFRARED-ON
DELAY START
SET TEMP
INFRARED-ON