Oregon Scientific TREVISO SLEEK BAR988HGA - Manual (Page 15)

EN
14
ATOMIC CLOCK
The RTGR368NA remote sensor collects time and
temperature information and transmits this back to the
main unit. The current time and date is received by radio
signal from the Atomic Clock broadcast located in Boulder,
Colorado. For more information on the Atomic Clock,
please visit www.nist.gov
Initial reception takes 2-10 minutes, and is initiated when
you first set up the unit, and whenever you press RESET.
Once complete, the reception icon will stop blinking.
The icon shown in the Clock Area indicates
2 factors:
• Connection between the main unit and the sensor
that collects atomic clock signals (
)
• Atomic clock signal reception ( )
How these signals work together:
To force a manual search for atomic clock
reception, press and hold SEARCH on the sensor
(RTGR328NA) for 2 seconds.
TURN ATOMIC CLOCK ON / OFF
If you wish to manually set the clock, you must first
disable the atomic clock feature. To do this, navigate to
the Clock / Alarm Area. Then, press and hold DOWN on
the main unit for 2 seconds. To enable it, navigate to the
Clock / Alarm Area, then press and hold UP for
2 seconds.
Atomic clock enabled:
ICON MEANING
The unit has contact with the
sensor and has synchronized the
time.
The unit has contact with the
sensor but the time has not been
synchronized.
ICON MEANING
The unit has lost contact with the
remote sensor but the time is
synchronized.
The unit has lost contact with the
remote sensor and the time is not
synchronized.
The unit cannot reach the remote
sensor.
NOTE
BAR988HGA English R5 9/18/04, 3:00 AM 14