Oki BISM2 - Manual (Page 28)

www.ezurio.com
12.4.2 FCC and Industry Canada Statements
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
12.4.2.1 FCC Labelling requirement
If the FCC ID is not visible when the module is installed inside another device, then the outside of the
device into which the module is installed must also display a label referring to the enclosed module.
This exterior label can use wording such as the following: “Contains Transmitter Module FCC ID:
PI401B” or “Contains FCC ID: PI401B.” Any similar wording that expresses the same meaning may be
used.
13. Environmental
13.1 Operating temperatures
13.2 Storage temperature
13.3 Reliability
Parameter Test Comment
Thermal Shock 200 cycles -40ºC /+85ºC 30 min 1 cycle/hour
Vibration Continuous operation at 60 Hz,
2mm stroke 15g max sine wave, 12 hours
Shock 50G 11ms Half Sine Wave 6 axis x 3 cycles each axis
Moisture Resistance
High Temp Storage 85ºC, 360 hours
Low Temp Storage -40ºC, 240 hours
High Temp/Humidity
Operation 60ºC, 90%RH, 360 hours
Thermal shock -40 to 60ºC in 30min 200 cycles with continuous
operation
Electro Static Discharge EN55024:1998 & IEC61000-4-3
Drop Test 75cm to concrete, 3 axis x 2
cycles per corner
Parameter Min Typ Max Unit
Operating temp (standard product) -40 25 +85 °C
Parameter Min Max Unit
Storage temp -40 +125 °C