Sylvania 6309CD - Manual (Page 19)

- 19 - EN
9J27
Make sure ...
• TV/VCR power must be turned on.
• Insert a cassette tape with its erase prevention tab in place. (If necessary, rewind or fast forward the tape to
the point at which you want to begin recording.)
NOTE: This unit will ONLY record and view the same channel.
You can ONLY watch the same TV program that is
being recorded.
1 Select the channel to be recorded
Press the number buttons on the
remote control or the CHANNEL
K
or L button.
Remember: If the TV/VCR is con-
nected to a cable box or satellite
box, the TV/VCR must be on CH3
or CH4, then the channel to be recorded must be
selected on the cable box or satellite box.
2 Select the tape speed
Press the SPEED button to select
the desired tape speed (SP/ SLP).
3
Begin recording
Press the RECORD button.
4
Stop recording
Press the STOP button when recording is completed.
NORMAL RECORDING
Press the PAUSE/STILL button to
temporarily stop recording.
Press the PAUSE/STILL or
RECORD button to resume record-
ing.
NOTE:
• After five minutes, the TV/VCR will automatically
switch to the Recording mode to prevent tape dam-
age.
SKIPPING UNWANTED
SCENES DURING RECORDING
CH 10
SP
REC
SP
PAUSE
SP
OTR (One Touch Recording)
This function enables you to set a recording length
simply by pressing the REC/OTR button on the
TV/VCR.
Make sure ...
• TV/VCR power must be turned on.
• Insert a cassette tape with its erase prevention tab in
place. (If necessary, rewind or fast forward the tape
to the point at which you want to begin recording.)
NOTES:
• This function CANNOT be done from the remote
control.
• Recording starts immediately when the REC/OTR
button is pressed.
• When the REC/OTR button is pressed 18 times, the
TV/VCR returns to the Normal Recording mode.
• To stop the OTR operation, press the STOP button
on the TV/VCR or on the remote control.
• To show the remaining time, press the DISPLAY
button on the remote control so that “OTR” appears
on the TV screen. (It will show up momentarily then
disappear.)
• Recording stops when 0:00 is reached.
• Please note that in the SLP mode maximum record-
ing time, assuming the tape is started at the begin-
ning, is 8 hours using T-160 (or 6 hours using T-120).
• If the tape runs out before the end time, the
TV/VCR will switch to the Stop mode immediately,
ejects the tape and turns itself off.
• If you press the power button during OTR, the
TV/VCR continues recording until the selected
length is reached.
1 Select the channel to be recorded
Press the number buttons on the remote control or the
CHANNEL K or L button.
Remember: If the TV/VCR is connected to a cable
box or satellite box, the TV/VCR must be on CH3 or
CH4, then the channel to be recorded is selected on
the cable box or satellite box.
• If you press the power button during OTR, the
TV/VCR continues recording until the selected
length is reached.
2 Select the tape speed
Press the SPEED button to select the desired tape
speed (SP/ SLP).