End panel layout – Orion Car Audio 4004 User Manual
Page 6
END PANEL LAYOUT
1.
Power LED - when lit indicates that the amplifier is on.
2.
Front Crossover Switch - configures the front channel for high-pass, low-pass,
or full range operation.
3.
Front Gain Control - continuously adjusts from 200mV to 5V for full power output.
4.
Front High-Level Input Connector - accepts input from head unit's speaker output.
5.
Front RCA Inputs - accepts RCA input from a source unit, preamplifier, or equalizer.
6.
Rear RCA Inputs - accepts RCA input from a source unit, preamplifier, or equalizer.
7.
Rear High-Level Input Connector - accepts input from head unit's speaker output.
8.
Rear Gain Control - continuously adjusts from 200mV to 5V for full power output.
9.
4CH / 2 CH Switch - configures the amplifier for two or four inputs.
10. Rear Crossover Switch - configures the rear channel for high-pass, low-pass, or
full range operation.
11. INTELLi Bass Control - continuously adjusts from 0 to 10dB of boost centered at
45Hz on the rear channels.
12. Speaker Connections - accepts up to 12-gauge speaker wire.
13. 2 x 30A ATC Fuses - protect the amplifier from over current situations.
14. REM Remote Turn-On Input - turns on the amplifier when fed 12 V+.
15. Power Connections - accepts greater than eight-gauge power and ground
cables.
5
©2003 Directed Electronics, Inc.