Omega 9000 User Manual
Page 7
NG
TO ASSEMBLE
NOTE: For best results, go through the assembly procedures, carefully
noting all cautionary points and hints, which are included for your
understanding and benefit.
STEP 1
Place bowl on motor base housing with spout facing you and
in the middle of the two raised projections.
STEP 2
Place strainer basket inside bowl, making certain that it rests
flat on platform center hex nut.
STEP 3
Insert cutter blade inside strainer basket with teeth up
centering it over hex nut.
STEP 4
Tighten clutch nut finger tight.
STEP 5
Insert optional filter liner into strainer basket.
STEP 6
Place cover on bowl with feeder chute opening to rear.
STEP 7
Place tabs of both latch arms over cover and secure.
STEP 8
Insert plunger in cover opening.
TO DISASSEMBLE
STEP 1
Remove plunger from cover opening.
STEP 2
Release both side latch arms by inserting finger into side
opening at bottom of the motor base and pulling upward.
STEP 3
Remove cover.
STEP 4
Unscrew clutch nut by turning counter-clockwise.
STEP 5
Lift out cutter blade from inside strainer basket.
STEP 6
Remove strainer basket.
STEP 7
Remove bowl.
OMG-259_9k_1k_manual_r1.qxd 4/22/05 11:33 AM Page 7