Installing the mid/woofers – Orion Car Audio XTR52 User Manual

Page 5

INSTALLING THE MID/WOOFERS

Step 1: Determine where the speakers will be mounted. Make sure there is a flat area large

enough for the speakers to fit properly. An uneven mounting surface can damage the
driver.

Step 2:

Check to make sure the space you have chosen for the speakers will not interfere with
the operation of the vehicle.

Step 3:

Using the supplied template guide, mark the mounting hole and mounting screw hole
locations with a pen for each speaker.

Step 4: Cut the holes for the speaker. When using correctly sized factory locations, this step

can be passed. A hole can be cut either with a pair of metal tin snips, an air or jig saw,
or with a hole saw corresponding to the size of the midrange listed below.

o 4-3/4" Hole Saw (5-1/4" woofer installation)

o 5" Hole Saw (6-1/2" woofer installation)

WARNING: Check for clearance of window mechanisms and electrical wires BEFORE you drill.

Step 5:

Run the speaker wire to the speakers. Make sure to keep wires away from sharp metal
or other edges. When passing through metal, use a protective grommet.

Step 6:

Pre-drill mounting screw holes using a 1/8" drill bit.

WARNING: Check for clearance of window mechanisms and electrical wires BEFORE you drill.

Step 7: Pull the wire through the speaker opening and connect to the speaker. Be sure to

observe proper mid/woofer polarity during this process.

Step 8:

Mount the speaker- Place the speaker and the grille in the installation hole. Align the
mounting screw holes and drive in the four mounting screws.

Screws

Speaker

Wiring
Harness

Panel

Figure 3
Figura 3
Abbildung 3

This manual is related to the following products:

XTR62