Set up for use, Channel set up for the first time, Deleting (or adding) channel – Sylvania C6513DD User Manual
Page 14
– 14 –
EN
0C28
– 14 –
You can program the tuner to scan all the channels you receive in your area.
NOTE: Channel memory programming is NOT needed when connected to a cable box or satellite box. Just
select the TV/DVD channel selector to the output channel of the cable box or satellite box (Ex CH3). Then
select the channel to be viewed on the Cable Box or Satellite Box.
CHANNEL SET UP FOR THE
FIRST TIME
1
Plug in the TV/DVD power cord
Plug the TV/DVD power cord into a
standard AC outlet.
NOTE:
•
If some digits appear in the corner of
the screen, press POWER without
unplugging the power cord.
2
Turn on the TV/DVD
Press POWER to turn on the TV/DVD.
3
Select the On Screen
Language
Press K or L to point to “LAN-
GUAGE”.
Then, press ENTER to select
“ENGLISH” or “ESP”=Spanish or
“FRA” =French. “[ ]” indicate the selected language.
4
Begin auto preset
Press K or L to point to “AUTO
PRESET”. Then, press ENTER.
The tuner scans and memorizes all
active channels in your area.
NOTES:
•
The TV/DVD distinguishes between standard TV
channels and cable(CATV) channels.
•
The TV/DVD may memorize TV channels as
CATV channels if reception conditions is poor. If
this happens, try AUTO PRESET action again
when reception conditions are better. See “CHAN-
NEL SET UP AGAIN” on page 15.
5
After scanning
The tuner stops on the lowest memorized channel.
If you want to recall the selected channels, you can
select the desired channel directly with Number or
CHANNEL(CH.) K or L.
TV
DELETING (OR ADDING)
CHANNEL
The channels you no longer receive or seldom watch
can be deleted from the memory. (Of course, you can
add the deleted channel into the memory again.)
1
Select “CHANNEL SET UP”
Press SETUP on the remote control.
Press K or L to point to “CHAN-
NEL SET UP”.
Then, press ENTER.
2
Select “ADD/DELETE CH”
Press K or L to point to
“ADD/DELETE CH”.
Then, press ENTER.
3
Enter the desired channel number
Press K or L until your desired
channel number appears. (You can
also use Number or CH. K/L to
enter it.) (Example: CH8)
4
Delete (or add) it from (into) memory
Press ENTER. The channel number changes to light
red. The channel is deleted from memory.
•
To delete another channel, repeat steps [3] and [4].
•
If you press ENTER again, the channel is memo-
rized again.
5
Exit the channel setup mode
Press SETUP on the remote control to returns to TV
mode.
NOTE: To confirm that channel(s) has been deleted
or added, press CHANNEL(CH.) K or L.
Added channel: Light blue.
Deleted channel: Light red.
TV
– SET UP –
B
LANGUAGE
[ENGLISH] ESP
FRA
AUTO PRESET
– SET UP –
LANGUAGE
[ENGLISH] ESP
FRA
B
AUTO PRESET
- TV SETUP -
B
CHANNEL SET UP
V-CHIP SET UP
LANGUAGE [ENGLISH]
CAPTION [OFF]
– CHANNEL SET UP –
B
ADD / DELETE CH (TV)
AUTO PRESET
08
ADD / DELETE
SET UP FOR USE
TV SECTION
TD704/804.QX33 03.4.15 4:35 PM Page 14