Olympus VN-702PC - Manual (Page 11)

11
1
EN
C
A
B
Po
w
e
r s
u
p
p
ly
/ H
O
LD
Power supply
Turning on/off the power
Turning on the power
While the recorder is turned off,
slide the POWER / HOLD switch to
the direction of the arrow.
Turning off the power
Slide the POWER / HOLD switch to
the direction of the arrow, and hold
it for 0.5 seconds or longer.
• The resume function remembers the stop
position before the power is turned off.
Power save mode
If the recorder is on and stops for 5
minutes or longer, the display shuts off
and it goes into power save mode.
• To exit power save mode, press any
button.
Set the recorder to HOLD mode (
A)
Slide the POWER / HOLD switch to
the [ HOLD ] position.
• After [ Hold ] appears on the display, the
recorder is set to HOLD mode.
Notes
• If you press any button in HOLD mode,
the clock display lights for 2 seconds, but
the recorder will not operate.
• If HOLD is applied during playback
(recording), operation is disabled
with the playback (recording) state
unchanged (When playback has ended
or the recording has ended due to the
remaining memory being used up, it will
stop).
Exit HOLD mode ( B)
Slide the POWER / HOLD switch to
the
c position.
HOLD