Omega Engineering PSW2000 - Manual (Page 4)

Dialog item Value Description
0 ... 400 Display of the actually measured value
.... Select the display unit
Activation of the unit display
....
0 ... xxx Switch-on point for SP1; if the ON value is smaller than the OFF value the
switching point evaluation is falling
0 ... xxx Switch-off point for SP1
0.0 s ... 9.9 s Switch-on delay for SP1 in seconds
0.0 s ... 9.9 s Switch-off delay for SP1 in seconds
.... Inversion of switching output SP1
Only models with 2nd switching contact:
0 ... xxx Switch-on point for SP2; if the ON value is smaller than the OFF value the
switching point evaluation is falling
0 ... xxx Switch-off point for SP2
0.0 s ... 9.9 s Switch-on delay for SP2 in seconds
0.0 s ... 9.9 s Switch-off delay for SP2 in seconds
.... Inversion of switching output SP2
List of functions:
4
= mbar
= bar
= unit display on (every 30 sec)
= no unit display
= psi x 10
= Window technology
= standard evaluation
= high-level-fail-save (normally open function)
= low-level-fail-save (normally closed function)
= high-level-fail-save (normally open function)
= low-level-fail-save (normally closed function)
= error output
= Window technology
= standard evaluation
= error output
= psi
= hPa
= mPa
PSW2000.qxp 6/12/2008 10:38 AM Page cov-6