Optimus STAV-3780 - Manual (Page 29)

29
Using the Remote Control
Receiver/Amplifier Operation
Before operation, press TUNER to select receiver/amplifier operation.
STATION Tunes to the next higher or lower memory location.
BAND Selects the AM or FM tuner band.
TUNING Tunes to radio stations.
MPX Selects the FM reception mode.
CLASS Selects the memory class.
DIRECT ACCESS Allows direct input of the station frequency.
Number Buttons Select the corresponding memory station. During Direct Access,
enter the station’s frequency.
– SW LEVEL+ Controls the sound level of the subwoofer when pressed after
SURROUND.
– REAR RIGHT LEVEL+ Controls the sound level of the rear speakers when pressed after
SURROUND .
TEST TONE Sounds test tones from each speaker when pressed after SUR-
ROUND .
– REAR LEFT LEVEL+ Controls the sound level of the rear speakers when pressed after
SURROUND .
CENTER MODE Selects among the three center modes or 3CH Logic when
pressed after
SURROUND in Dolby Pro-Logic mode .
– CENTER LEVEL + Controls the sound level of the center speaker when pressed af-
ter
SURROUND .
DELAY TIME Sets the rear-channel delay for Dolby Pro Logic Surround pro-
grams when pressed after
SURROUND .
– EFFECT + Adjusts the level of DSP mode.
SURROUND Sets the remote control into the surround setup mode.
PRO LOGIC Selects Dolby Pro Logic Surround.
DSP MODE Selects the DSP mode; HALL, JAZZ, DANCE, THEATER 1, or
THEATER 2.
MUTING Silences the receiver. Press again to restore the sound to its pre-
vious level.
VIRTUAL Selects virtual surround mode; DOLBY VIRTUAL, SRS1, or
SRS2.
5-D THEATER Selects 5-D Theater mode.
+ MASTER VOLUME – Adjusts the system’s volume.
RECEIVER POWER Turns the receiver on and off.
FUNC Selects a program source (VCR, PHONO, tuner, CD, DVD/TV, or
LD/SAT). Repeatedly press until the display shows the desired
program source.
DIRECT Bypasses the receiver’s audio control circuits. Press again to re-
store the previous settings.
CONTROL
MODE
Receiver/
Amplifier
Buttons
TUNER